3gx 2.0 with telemetry tm1000

[Jackass1277]

i know this is probley posted somewhere else but after firming up to 2.0 last night and fooling around with my telemetry module i got it working without the spektrum ar8000. if you use the power out on the 3gx to the "data" on the tm1000 and rebind it works. just thought i would put it out there.

[Lunar Wolf]

Did this on 1.2 ages ago, as far as I know its always worked you just don't get the holds/fades info as the 3GX dosn't output that data.

[JoeW]

Originally Posted by Lunar Wolf

Did this on 1.2 ages ago, as far as I know its always worked you just don't get the holds/fades info as the 3GX dosn't output that data.

1.1 was the earliest release I tried, same result.

would be nice to see them support the Rx data.

I plug mine in to the s.bus/bind port... I should try the bat/aux port to see if I get any different data.

[Lunar Wolf]

oops my bad, i'm in the bind port as well.