unkown part number, need help

[skiprima]

On the 400 where the see saw holder is attached to the headblock, there are 2 bushings that hold the short arms in place. There are 2 tiny little screws that fasten the seesaw holder in place once the bushings are place over the seesaw arms.
Does anyone know what size bushings these are and a part number for them?
A close measurement with my calipers puts the bushings at 6mm in diameter, 2.5mm in width and a hole of appox 2.9mm.

TIA

[aranciata]

hello
if you speak of plastic stock and i understand right , the part is EFLH 1417 MAIN GRIP FOR BLADE 400 .See you if they are... ( ONLY AXLE BOX PRESENT )
http://www.horizonhobby.com/products...-b400-EFLH1417
IF you speak of flybar seesaw holder it are BALL BEARING...
The BALL BEARING with dimension 3x6x 2,5 mm are code is BLH 1115
i hope help you...
sorry my english , but i'm italian....
hello

[Harbormaster]

The exploded diagram is often helpful at times like this...
http://www.bladehelis.com/prodinfo/F...0_Exploded.pdf

[skiprima]

Thank you both for the reply. It turns out that the the parts are the same on the 450 as is the see saw holder. Part # 1666.
This was inadvertantly left off the explosed parts diagram with the 400. Originally it was part # 1466.