Register Now

towertsk · 04-20-2011, 11:01 AM

I'm thinking about converting one over. I have a Xera 4030 3Y with the normal shaft. Can someone tell me the distance between the outside edges of the motor mount or how long the shaft needs to be to reach the counter bearing?

Thanks

j2m · 04-27-2011, 05:38 AM

I have a G Force conversion kit with a Scorpion long-shaft 4035. I can't measure it because I'm not at home but the shaft needs to be at least 30mm long I would say

mlucia · 05-23-2011, 10:32 AM

Right on Gforces website it says the length needed for future reference:

http://www.gforceheli.com/c291071_en...p17574833.html

Quote:

*** It is highly recommended that you use a motor with a 6mm diameter pinion shaft that is at least 35mm long protruding from the motor casing. Most motor makers now have longer shaft kits.

04-20-2011, 11:01 AM	#1 (permalink)
towertsk Registered Users Join Date: Jan 2009	G-Force Conversion help I'm thinking about converting one over. I have a Xera 4030 3Y with the normal shaft. Can someone tell me the distance between the outside edges of the motor mount or how long the shaft needs to be to reach the counter bearing? Thanks __________________ Odin 90 FBL, Trex 700N FBL, Velocity 50, Trex 600N FBL, JS Frenzy, Logo 600SE, Fusion 50, Trex 550 FBL stretch, 2 x Protos, Trex 500 FBL, Trex 450Pro

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

04-27-2011, 05:38 AM	#2 (permalink)
j2m Registered Users Join Date: Aug 2005	I have a G Force conversion kit with a Scorpion long-shaft 4035. I can't measure it because I'm not at home but the shaft needs to be at least 30mm long I would say

Register Now

Log-in