START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
500 Class Electric Helicopters 500 Class Electric Helicopters manufactured by Align, Tarot, SYMA, Airhog, Chaos, HK and similar. |
|
LinkBack | Thread Tools | Display Modes |
05-21-2013, 04:44 AM | #1 (permalink) |
Registered Users
|
Align esc problem
Hi lads, i'm having a problem with either my align 70a esc or the motor, when I pug in the battery the esc does not beep, there is power to my rx and all electronics work fine but when I throttle up there is no motor jus the swash moving up??
I have had a tester on the 3 wires off the esc and there is 23v coming from it whats the problem? is it my esc or is it the motor?? Any help appreciated? Thanks.
__________________
Dx7S T rex 450l Dominator x2 - T rex 500l Dominator - T rex 550l Dominator - Radian Pro - Radian Eflite Inverza |
Sponsored Links | |||
Advertisement |
|
05-21-2013, 06:30 AM | #2 (permalink) |
Registered Users
Join Date: Sep 2011
|
Have you checked the connectors on the motor. I've had this happen to me and it has been a bad solder joint on one of the motor connectors. This was on a 250 but the same principal applies
|
05-21-2013, 05:29 PM | #3 (permalink) |
Registered Users
|
The motor is where the beeping comes from, so like the other post check your wires on the motor, other than that I would guess motor first.
Craig |
05-21-2013, 10:48 PM | #4 (permalink) |
Registered Users
|
Just a though, but make sure you haven't accidentially dialed in some throttle trim that would cause the esc not to initilize.
__________________
Trex 500-3226-1600, 14T, Koby 90LV, HS-5245MG, DS655, AR7200BX, DFC Trex 450 Sport-2221-8, 15T, CC Edge 50 Lite, HS-5065MG, HSG-5084MG, AR7200BX, DFC DX8 |
Thread Tools | |
Display Modes | |
|
|