YGE LV 120 vbar gov

[maarset]

Trying to get my vbar gov on my logo 500 to work with my yge. In setup I'm getting 0 for current speed. It spools up and I have different speeds for each flight mode. I get magnet light but no gov active light. I tried two different sensors. Using 4% start and plane middle. Yge gov is disabled.

Also what esc does Uri use on his logo 400 that spins the opposite way?

Thanks
Mike


Sent from my iPhone using Tapatalk

[maarset]

Maybe the Hyperion sensor isn't working cause I'm using a buffer pack and the built in BEC on the YGE?


Sent from my iPhone using Tapatalk

[MrMel]

Cant answer on YGE LV and Phase sensor, try a ground cable and see.

Spinning other way has nothing to do with ESC used, it's just swapping 2 motor cable and turning the one-way upside down.

[maarset]

Originally Posted by MrMel

Cant answer on YGE LV and Phase sensor, try a ground cable and see.

Spinning other way has nothing to do with ESC used, it's just swapping 2 motor cable and turning the one-way upside down.

Oops I meant Uli, Uli Röhr. Not Uri. He has a Logo 400 that is setup with the blades turning counter clockwise and I was just curious if anyone knew what esc he uses on it. He probably uses a bunch of different ones since it is his test bird.

So if I was to try and use a ground lead where would I connect it to? I was always confused abotu that one.

[maarset]

Well I added a wire from buffer pack to flight pack, negative sides and phase sensor WORKED!!

Now I just hope the spool up is better than castle/vbar gov


Sent from my iPhone using Tapatalk