START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Flight Controllers (NAZA, Wookong, A2, etc...) Flight Controllers (NAZA, Wookong, A2, etc...) |
|
LinkBack | Thread Tools | Display Modes |
03-25-2012, 10:46 PM | #1 (permalink) |
Registered Users
Join Date: Oct 2009
|
Naza VU bec voltage output
What is it? Looking to get servos ordered tonight for my f450 and really don't want to run a seperate bec unless I have to.
__________________
Nikon D4/Sony Fs700/Cinestar 8/8FG super/Dx8 |
Sponsored Links | |||
Advertisement |
|
03-25-2012, 10:51 PM | #2 (permalink) |
Registered Users
|
Per the Naza specs, 4.8-5.5v for voltage to the MU and therefor to your gimbal servos. I use s separate BEC and drive the servos at 6v. The CC 10A bec is not that large and is programable.
__________________
AMA #844172 DJI S1000 Lightbridge Zen for 5D, S900 LB Zen for BMPCC, DJI Phantom 2 Vision +, P2Z2 with Data Link, P2Z3 with LB DJI Forum Support |
08-04-2012, 06:32 PM | #3 (permalink) |
Registered Users
Join Date: Jul 2011
|
I want to use CC 10A BEC too, do I have to remove red wire from Naza VU or can I just connect CC BEC to my receiver without any modifications?
|
08-05-2012, 09:01 PM | #4 (permalink) |
Registered Users
Join Date: Dec 2010
|
I would just use the signal wire from the NAZA and power the servos off a BEC.....
|
08-05-2012, 09:10 PM | #5 (permalink) |
Registered Users
Thread Starter
Join Date: Oct 2009
|
X2. I've come a long ways since this thread started lol
__________________
Nikon D4/Sony Fs700/Cinestar 8/8FG super/Dx8 |
Thread Tools | |
Display Modes | |
|
|