START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
JR and Spektrum Radios and Electronics JR and Spektrum Radios, Gyros, Servos, Etc. |
|
LinkBack | Thread Tools | Display Modes |
05-20-2015, 09:57 AM | #1 (permalink) |
Registered Users
|
Receiver battery
Hey guys I need to replace my receiver battery for binding procedures. I had a spektrum that had 3 leads on it. I am looking at a cheap charger and battery pack for $15 off ebay. I don't meed fancy just need it to work once and a while when binding a new model during a build. Does the battery need a signal cable to plug into the receiver to be able to bind or does the receiver simply need a power source and ground? I know I need the bind plug but do I need a 3 wire plug or is 2 sufficient?
This is what I am looking at. I have a bind plug. Will this work for binding purposes? http://m.ebay.com/itm/191326881395?nav=WATCHING_ACTIVE Thanks
__________________
Mcpx Microheli, Mcpx BL rakonheli, 600N LE Blackout mini h FPV race quad Blackout mini hex fpv race quad |
Sponsored Links | |||
Advertisement |
|
05-20-2015, 07:01 PM | #2 (permalink) |
Registered Users
Join Date: Jun 2008
|
It only needs power and ground.2 leads.
That should work fine.
__________________
Too many helis & Too many planks Lots of DX radios & A couple Futaba 72mhz radios AMA member & Full scale plank driver HELIFREAK !!! |
Thread Tools | |
Display Modes | |
|
|