START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Scorpion ESC and Motor Support Scorpion Power Systems ESC and Motor Factory Support Forum |
|
LinkBack | Thread Tools | Display Modes |
04-15-2012, 01:00 PM | #1 (permalink) |
Registered Users
Join Date: Jul 2010
|
Vbar governor setup help
Hello, I am using the Scorpion 130A ESC and trying to set up my Vbar governor and starting with MrMel's video (i'm using v5.1 on the Vbar so that is the video i'm following, not the remake), he starts off with using channel 7/AUX2 in TX for the "control channel" as far as i can tell, and I'm using an 11X and I do not see an AUX 2 in my travels in order to set the throws. On the channel list, there is a "---" where AUX 2 should be, and then it continues to AUX 3, 4, etc. I'm confused on how to get this part to work..
__________________
Eric Olson: Team SAB Team Pulse Ultra |
Sponsored Links | |||
Advertisement |
|
04-15-2012, 01:01 PM | #2 (permalink) |
Registered Users
Join Date: Apr 2005
|
ESC is made for 5.2, I suggest you update as it's a perfect match then.
|
04-15-2012, 05:04 PM | #3 (permalink) |
Registered Users
Thread Starter
Join Date: Jul 2010
|
Now we're getting another little problem. On the Governor I tab of the interface, we have our Output Socket tab dropdown on "Collective/ESC" because I am not running a seperate reciever. At 50 imput on the TX stick, it is showing a value of 0 on that bar, but when the TX stick is at either extreme (-100 or +100), the bar is showing +20. Shouldn't this be showing -100 and +100 in correspondence to the throttle stick input? We also have adjusted the throttle ATVs in order to achieve a value of -100 and +100 for the ESC bar on the "transmitter" tab.
__________________
Eric Olson: Team SAB Team Pulse Ultra |
Thread Tools | |
Display Modes | |
|
|