UAV Quad, great autonomous waypoints flyer!

[magimat]

This is my custom made quad, based on my homemade wooden frame.

Frame measures 24" between motor shafts diagonally and there is plenty of place to add stuff. I was planning on adding fpv gear, but I decided to sell it and move on to another project.

This quad flies really well (see video below) and all is needed is a radio and your own RX. (AR7000 on the photos will be removed before shipping, unless dealed otherwise).

You'll need to make sure radio calibration and flight modes are set correctly before flying, but if you know your way around the mission planner software, this is an easy task.

You can either fly this quad manually or use the software to plan some waypoints navigation and just watch it fly itself!

Here is the full detail of this quad:

Homemade wooden frame with lots of extra space (24" shaft to shaft)
APM 2.6 flight controller w/ latest arducopter firmware
3DR uBlox GPS with Compass Kit (LEA-6H)
4x 3DR AC2830-358 850Kv motors
4x 3DR 20amp ESC flashed with SimonK firmware
4x 10 x 4.7 plastic props
3DR radio telemetry kit (915Mhz US) /w whip antennas (tx on quad and usb rx)
3S 5100mah 35C lipo


BONUS:

2 extra sets of props (8 additional props)
4 extra 20 amp ESC, not SimonK (can be reflashed if you know how)
1 extra 850kv motor
1 Y telemetry cable (to add OSD)


I'm asking 425 USD, PM me for shipping quote.


Demo video:

[magimat]

price drop bump!

[magimat]

bump!

[magimat]

bump

[magimat]

bump