START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Kontronik Drives Jazz and Jive ESC's and other Kontronik equipment support |
|
LinkBack | Thread Tools | Display Modes |
05-23-2014, 09:21 PM | #1 (permalink) |
Registered Users
Join Date: Feb 2012
|
How to remove jive 120hv heatsink
if installed using arctic silver?
|
Sponsored Links | |||
Advertisement |
|
05-23-2014, 10:17 PM | #2 (permalink) |
Registered Users
Join Date: May 2011
|
If its the adhesive it is pretty much permanent. Some people have been able to pry it off but I would not suggest it as you can break the heat sink plate out of the case.
__________________
Richard Zappe Team Kontronik USA PeakAircraft |
05-24-2014, 01:52 AM | #3 (permalink) |
Registered Users
|
Very easy. Dremmel out one corner of the heat sink just above the Jive metal plate... put in a small flat head screw driver and twist... since you are twisting against the two different pieces.. there is no force pulling on the Jive's plate.. the sink pops right off.
__________________
"It's not just a hobby... it's a lifestyle" - Pete ϟ MINNESOTA! Goblin 500 + 700 / SK540 / Jives / DX8 / Quantum / RJX servos / 306b / Deep cycles |
Thread Tools | |
Display Modes | |
|
|