V Bar Tail Setup

[gerardobrandao]

Hello i´m using Vbar 5.2.5


2 questions



1º st

When triming mine swash plate at the swash menu i get a pefect leveled swash plate from minimum pitch, zero collective and full pitch!Problem is that when i get out of the swash setup menu, the swash plate goes to the same "non" leved trim.....What am i doing wrong?

2ºnd

I know that i will get multiple answers....
Mine mks DS 760 burned, but it wasn´t a servo problem....It was mine mistake...i was setting up the tail endpoints, and the srvo binded and i didn´t noted ..Mine mistake...

I have to opt for a new one...

Waiting for comments...In mine mind i have 3

a new DS 760
a Futaba BLS 251
a MKS BLS 980


Waiting for input....Best Regards

[alexmit]

Originally Posted by gerardobrandao

Hello i´m using Vbar 5.2.5


2 questions



1º st

When triming mine swash plate at the swash menu i get a pefect leveled swash plate from minimum pitch, zero collective and full pitch!Problem is that when i get out of the swash setup menu, the swash plate goes to the same "non" leved trim.....What am i doing wrong?

2ºnd

I know that i will get multiple answers....
Mine mks DS 760 burned, but it wasn´t a servo problem....It was mine mistake...i was setting up the tail endpoints, and the srvo binded and i didn´t noted ..Mine mistake...

I have to opt for a new one...

Waiting for comments...In mine mind i have 3

a new DS 760
a Futaba BLS 251
a MKS BLS 980


Waiting for input....Best Regards

1st - This is completely normal out of setup mode. Ignore it.
2nd - All of those strike me as good servo choices for the tail.

[gerardobrandao]

Thank for your input....



So assuming that in setup mode the swash is leveled from the entire range...lower zero pitch and full pitch.....when out of the setup and flyking it will act the same way like in setup mode....am i right!!!?


Best regards

Sent from my GT-I9100 using Xparent ICS Tapatalk 2

[Deet]

Originally Posted by gerardobrandao

Thank for your input....



So assuming that in setup mode the swash is leveled from the entire range...lower zero pitch and full pitch.....when out of the setup and flyking it will act the same way like in setup mode....am i right!!!?


Best regards

Sent from my GT-I9100 using Xparent ICS Tapatalk 2

Any FBL controller will do strange things sitting on the bench, only in flight will you sees if there is an issue

Two questions

Do you have the trims at 0 on the radio?

Did you properly set the radio centres and endpoints on the TX setup tab?

[gerardobrandao]

Originally Posted by Deet

Any FBL controller will do strange things sitting on the bench, only in flight will you sees if there is an issue

Two questions

Do you have the trims at 0 on the radio?

Did you properly set the radio centres and endpoints on the TX setup tab?

Hello Deet


Thank you for your valuable input...
Yes in radio mode, the center is at 0% on TX menu and both side 100% and -100%......
I level it perfectly at the swash trim menu ...but as soon as it gets out of the setup menu, it gets a liitle bit out of trim.....!



May be this is normal....

Best Regards

[gerardobrandao]

Originally Posted by Deet

Any FBL controller will do strange things sitting on the bench, only in flight will you sees if there is an issue

Two questions

Do you have the trims at 0 on the radio?

Did you properly set the radio centres and endpoints on the TX setup tab?

By the way...isn´t that pic of your avatar, the space ship that taked Lew tenent ripley from USS Sulaco to Lv 427!???? Big Fan of alien movies...one of best ....


Regards

[gerardobrandao]

Originally Posted by alexmit

1st - This is completely normal out of setup mode. Ignore it.
2nd - All of those strike me as good servo choices for the tail.

Thank for your valuabele input Alex

Best Regards

[HiroboFreak]

Try a rebind.

[gerardobrandao]

Originally Posted by HiroboFreak

Try a rebind.

Hello


I´m using a separate Rx...Best regards

[torpedoarmed]

Originally Posted by gerardobrandao

By the way...isn´t that pic of your avatar, the space ship that taked Lew tenent ripley from USS Sulaco to Lv 427!???? Big Fan of alien movies...one of best ....


Regards

"On an elevator ride straight to hell... Going Dowwwn." et.al. Prvt Hudson

[gerardobrandao]

Originally Posted by torpedoarmed

"On an elevator ride straight to hell... Going Dowwwn." et.al. Prvt Hudson

LOLOLO

...Nobody touches nothing....

Best Regards..Over and Out....