START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Electric Helicopters Dedicated to larger than Micro/Mini Electric Helicopters of any Brand |
|
LinkBack | Thread Tools | Display Modes |
01-13-2012, 04:23 PM | #1 (permalink) |
Registered Users
Join Date: Jan 2012
|
Volitation 9053 flybar question
I bought a plastic flybar from the 9077 just not sure how to get the metal flybar off theVolitation 9053 .Is the pin thats in there just presure fit or what???? tried to push it out but not moving.Need help please . Thanks All.
|
Sponsored Links | |||
Advertisement |
|
01-13-2012, 05:29 PM | #2 (permalink) |
Registered Users
Thread Starter
Join Date: Jan 2012
|
I finely found a youtube video.It is a pressure fit pin.It is just going to need a good wack to get it out. Hope i don't break anything.
Last edited by martyisnuts; 01-14-2012 at 08:02 AM.. |
02-19-2012, 12:41 AM | #3 (permalink) |
Registered Users
Join Date: Jan 2012
|
The pin just knocks out, one end is bigger than the other so make sure you start in the right place!
I had one of these and I cut the metal flybar down each end to try and reduce blade strikes. Another good mod to make is flip the bottom blade holder upside down on the shaft to increase the distance between the rotors. I also put a slightly larger til rotor on to try and speed it up a bit in forwards/backwards flight. It worked a bit but the slightest breeze and it was a goner! I tried all sorts to try and make it a decent flyer ie regaining control in light winds but in the end I gave up. I think I expected too much from it to be fair, it's a great heli for what it is and is a great stepping stone to a more expensive cp heli |
Thread Tools | |
Display Modes | |
|
|