START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Blade 450X Blade 450X Helicopters Information and Help |
|
LinkBack | Thread Tools | Display Modes |
05-19-2012, 04:52 PM | #1 (permalink) |
Registered Users
Join Date: Dec 2011
|
Piros after crash
Long story short, I crashed my X a while back, replaced cyclic servos and bent/broken parts and then crashed again. I forgot to do step M in the beast setup (correction direction). The heli is flying again but the piros are VERY out of control. Before, they didn't require much correction but now when I piro, the heli gets wildly out of control. Does this have something to do with step J, or whatever step is piro optimization?
|
Sponsored Links | |||
Advertisement |
|
05-19-2012, 04:57 PM | #2 (permalink) | |
Registered Users
|
Quote:
__________________
Andreas M. Compass 7HVU Logo 600SX V2 Blade 450X |
|
05-19-2012, 05:38 PM | #3 (permalink) |
Registered Users
|
After a crash and a repair:
ALWAYS do the FULL BeastX setup. Every step. Don't skip it, takes ten minutes tops once you've done it two or three times.
__________________
Blade: mCX2, mSR, mSRX, Nano-CPX, 2x mCPX (v1), mCPX-BL, 120SR, 450 X Spektrum DX8, DX6i |
05-19-2012, 05:45 PM | #4 (permalink) |
Registered Users
Thread Starter
Join Date: Dec 2011
|
I did the piro optimization step and it seemed like the heli was functioning as it should for that step. I'll have to go back through and check
Btw I've been calling it piro optimization but it's really called piro compensation, haha, oops |
05-20-2012, 03:38 AM | #5 (permalink) |
Registered Users
|
+1000 , I didnt notice that you had changed cyclics. When you change servos or gearset, ALWAYS do a full beastX setup, I assume that your issue is that the swash is unlevel and the horns not exactly 90 to the servo and that step J - the 6 degrees is also messed up. If this is your first beastx setup, it may take well over half an hour, but once you do it once, you dont forget it.
__________________
Andreas M. Compass 7HVU Logo 600SX V2 Blade 450X |
05-20-2012, 01:39 PM | #6 (permalink) |
Registered Users
Thread Starter
Join Date: Dec 2011
|
Problem solved. Step N - piro compensation direction had to be changed. I'm assuming that because I had to reverse the new servos after installation that this step also had to be reversed. I watched a video to help me figure out what the swash should look like during this step
|
Thread Tools | |
Display Modes | |
|
|