Register Now

chezrock · 07-15-2007, 09:08 PM

I have a 450SE V2 that I just put together and finally got it 99% setup thanks to finless, the problem I am having is that no matter what I try or how I set it up my gyro is always flashing.

Rudder=CH4
Gain=CH7
Travels are 70 for HH and 35 for regular (Just as a starting point)
If I reverse CH7 the gyro works as advertised, when I next plug in my battery I have to un-reverse ch7 to get the gyro to work again, what the hell could I be doing wrong?

Great website by the way and after not flying anything for 4 years the finless videos were spot on.

victornhi · 07-16-2007, 03:02 AM

Gyro gain channel is normally CH-5. The Eclipse "gyro" menu lets you set from 0 to 100%, so setup in rate mode ( around 25%) then run in HH mode between 50% - 100% run as high as you can without the tail wagging.

07-15-2007, 09:08 PM	#1 (permalink)
chezrock Join Date: Jul 2007	Eclipse 7 Synth & 401 I have a 450SE V2 that I just put together and finally got it 99% setup thanks to finless, the problem I am having is that no matter what I try or how I set it up my gyro is always flashing. Rudder=CH4 Gain=CH7 Travels are 70 for HH and 35 for regular (Just as a starting point) If I reverse CH7 the gyro works as advertised, when I next plug in my battery I have to un-reverse ch7 to get the gyro to work again, what the hell could I be doing wrong? Great website by the way and after not flying anything for 4 years the finless videos were spot on.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

07-16-2007, 03:02 AM	#2 (permalink)
victornhi Registered Users Join Date: Sep 2006	Gyro gain channel is normally CH-5. The Eclipse "gyro" menu lets you set from 0 to 100%, so setup in rate mode ( around 25%) then run in HH mode between 50% - 100% run as high as you can without the tail wagging.

Register Now

Log-in