START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
2.4G Futaba Radios Futaba 2.4G Radio Help and support forum |
|
LinkBack | Thread Tools | Display Modes |
10-13-2014, 10:47 PM | #1 (permalink) |
Registered Users
Join Date: Sep 2009
Location: San Diego
|
8fg Nitro Heli - Can I have Throttle hold and CUT?
Greetings.
Is it possible to setup throttle hold and cut from either - 2 switches, or a 3 position switch. After reading the manual, and tweaking on the transmitter, I'm thinking no. Thanks in advance |
Sponsored Links | |||
Advertisement |
|
10-14-2014, 02:42 AM | #2 (permalink) |
Registered Users
Join Date: Jan 2012
|
You sure can. 2 switches is the easiest & it avoids making mistakes.
The throttle hold is the easiest & uses the built in throttle hold function, just set the position& the switch & you're good to go. The throttle cut also uses the built in, but needs a little more setting up. What part of the manual is giving you grief? What switches do you want to use? Citizen #186 |
10-14-2014, 09:10 AM | #3 (permalink) |
Registered Users
Thread Starter
Join Date: Sep 2009
Location: San Diego
|
I was reading pages 62,63 & 114, it seemed like they were doing the same thing.
I am using SD for the Throttle hold, and wanted to assign SH to the Throttle Cut. Thanks for the help |
10-14-2014, 09:43 AM | #4 (permalink) |
Registered Users
Thread Starter
Join Date: Sep 2009
Location: San Diego
|
I went back thru it, reread everything, and I think I got it, once I separated the two functions, they worked independently. I'll check it out 2moro after I replace bearings. Thanks for the help
|
Thread Tools | |
Display Modes | |
|
|