START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Beam Beam Helicopters Factory Support Forum |
|
LinkBack | Thread Tools | Display Modes |
04-25-2014, 12:02 PM | #1 (permalink) |
Registered Users
Join Date: Apr 2014
|
E4 tail question
Folks,
Does the new tail pitch slider and lever fit the old E4 tail body? If not, can I at least re-use the old blade holders on the new tail? Thanks!! Mark |
Sponsored Links | |||
Advertisement |
|
04-25-2014, 10:17 PM | #2 (permalink) |
Registered Users
Thread Starter
Join Date: Apr 2014
|
Update
I just re-read my post and realized I should be a little more precise....
I'm wondering if the SE tail pitch slider and lever fit on the V2 tail casing. If not, do I need upgraded blade holders in addition to the SE tail assembly? Thanks Folks!! Mark |
04-26-2014, 09:16 AM | #3 (permalink) |
Registered Users
Join Date: Oct 2013
|
I am not sure that will work. But I just installed the SE tail assembly which comes with the blade grips and it was well worth the money. It has a touch more travel and is way more ridged ..
http://www.amain.com/product_info.ph...g-Assembly-Set
__________________
------------------------------------------------------------------ " I am not a bad guy, I am just a underachiever making up for lost time". // Beam 450 ,FBL , BeastX // Goblin 500, BeastX // TT X50 Titan FBL, YS56, BeastX //Dx8 /. |
Thread Tools | |
Display Modes | |
|
|