Let's see your AHF!

[UPGl2AYDD]

Ok guys, time to liven it up a bit. Let's see some shots of your AHF's.

Dressed for action and nude (we all love us some HeliPorn right?).

(I'll post my two babies shortly, still setting the new one up!)

[antennaman]

Almost ready for the air!
Spektrum H6040's
Novarossi 57 / Outrage HR56
Planning on picking up a CJY Total-g
Tail servo undecided

[UPGl2AYDD]

Very nice! You'll have to post a few more angles, I wanna get those new Fusuno canopies, just can't decide between that and a different styled Trex one.

Everyone seems to be running 650's for the vast majority.

[kevinb120]

Here's the sunset one. I'm thinking I'm going to run the same GY520/DS650 combo as my 550.

[UPGl2AYDD]

Damnit... lol These canopies are making my stock yellow one feel inferior!

I was contemplating emails Fusuno and seeing if they could put a Trex's white/green paint combo on a Aeolus canopy for me. I know they do this as I seen others had it done.

[fly3d-NE]

Nice birds

[Chrisk7]

Here are a couple of mine. Love this machine, very cheap to fix, flies superb, looks large in the air, capable of doing mush more than I can throw at it.
Align/OS 50 Hyper, Fut 9252's, Align DS 610, GY 520 gyro (now Beast X) Throttle Jockey Gov. Align 600 blades.

I'm installing a Micro Beast in it tonight. Anyone else put the Beast X in their's? If so what did you use for sticky tape, the thick or thin?

http://rc.runryder.com/helicopter/gallery/8813/

[UPGl2AYDD]

Great stuff! I'll need to take pictures of my "twins" tonight.

[D A T T O]

heres my Aeolus 50 SV 3D
OS55 HZ, Funtech B320, Spartan Quark BLS251, 9252s, Edge mains and tails.

[UPGl2AYDD]

Awesome looking bird Matt,

What was the extent of the damage on her? Looks minimal?

[kevinb120]

Finally got it out in the sun! Didn't have time this week to pickup fuel tubing/filters, etc, otherwise it's GTG! Should have it done next week. The Torq servos are friggin gonzo fast. Not enough pics of our birds up here, so here's a few....

[SkyRaptor]

Kevin, thanks for the pictures... I had some doubts about routing the wires... yours pictures spot some light in my mind..

I'd be great if other guys do the same..

Thanks.

[kevinb120]

It's easy in one way and hard in another. Hard that everything is so close together you have a lot of slack, easy in that everything you do is hidden The gy520 has 3 very long leads and the servo is only 2" from the bus for the connectors and the receiver itself. I may substitute those 3 for some 3 and 4" extensions.

I just use pieces of velcro because it sticks not only to itself but the other straps here and there. You can wrap up like component wires then just have a chunk of strap bundle the bundles... At least with initial testing and setup, I wouldn't have to take too much apart to mess around with any one component. If I wanted to be picky I would cut everything to custom lengths, not so much an issue with everything under the lid though. And using the AR7100R and HV servos takes out two components I don't even need to add(regulator and governor).

The satellite seems to be a natural for sticking on the top like that just in front of the starter wand access, and you can see the confirmation light without taking off the canopy.