Vlink neo bad esc port?

[tshelby73]

I had a castle catch fire. I tried to program hobbywing esc and couldn't get anywhere. Anyway I plugged a servo into esc port and the servo had no response. Does this pretty much mean my esc output on neo is burned or am i missing something. All other servo work.


Sent from my iPhone using Tapatalk

[jadams]

The ESC port does not control a servo..

[JANtoolMAN]

I cant remember right now where I plug my throttle servo on the neo, but if it is the esc port, you could plug a servo in to test it?

[tshelby73]

Originally Posted by JBHAWAII

I cant remember right now where I plug my throttle servo on the neo, but if it is the esc port, you could plug a servo in to test it?

That's what I did and servo had no response. Think I'll try to send it in hopefully I don't have to send it to Germany.


Sent from my iPhone using Tapatalk

[Andy from Sandy]

The ESC port does not control a servo

The output pins will go from 1000uS to 2000uS unless it is the tail output set to narrow pulse width.

That pulse output can drive a servo.

Mikado offered a reasonable discount to me on a mini v-bar I burnt out that they couldn't repair.

If you have access to an oscilloscope you could check the output.

[JANtoolMAN]

Please keep us posted on the cost and how the replacement goes.

[tshelby73]

I filed a service ticket probably won't here back till Monday. They did give me a pretty good discount on a silver vbar They couldn't repair years ago and transferred my pro to the new one.


Sent from my iPhone using Tapatalk