HeliJive - Can't get autorotation bailout to work

[Luisito]

After performing mode 1 then mode 4 then switching the throttle hold switch I get the confirmations as per the manual but I never get the ring for the autorotation bailout. I have several HeliJives and I can't seem to get this one to work.

I tried throttle hold values from 15% to 20 % but no ring. I performed the exact steps as per the videos and manual using both stick programming and ProgDisk.

In the ProgDisk I reset it and perform the entire setup, then confirm all the values. It shows that autorotation is on but I never get the telephone ring after the cell count.

Any ideas? (Linear 0 to 100 throttle curve, 100% to 100% travel).

Luis

[Magneto]

Luis go one point at a time it may be over 20% to meet the agreed value between the radio and the HJ. The telle ring for bailout is a one time deal only when you meet the value during programming,During boot up there will be no tele tones unless its in KSA mode.

[Luisito]

Many thanks, I started doing that in the negative direction. I'll try from 20% and change it 1% at a time until I get the ring.

It would of been nice if you could dial it in until you get the ring versus setting it one point at a time and when it doesn't you have to start all over again.

[Luisito]

Ok, all solved. The final number that the HeliJive accepted for autorotation bailout was 35%. This was on a Spektrum DX8.