Can SomeBody help me with Phoenix and the aurora 9

[ThaDJ]

Hy Guys,

Could somebody please help me ??
I can fly my heli in Phoenix but none of the switches work.
Ive tryed everything but nothing works.


Hope that you guys can help me...

Thanx.
Dennis..

[motogman]

You have to assign a switch for what you want it to do same as when you set it up for real heli.

[ThaDJ]

yeah ok and if i set the b switch on my Aurora 9 for my gyro rates like for my heli does that work directly in phoenix or do i have to set something in phoenix too?

[motogman]

Not sure on gyro I never had to set it in Phoenix But duel rates expo and idle up switch no just set it up in radio then I recalibrate the radio and it works fine for me.

[Moktor]

Originally Posted by motogman

Not sure on gyro I never had to set it in Phoenix But duel rates expo and idle up switch no just set it up in radio then I recalibrate the radio and it works fine for me.

I was having no luck getting my switches to work, either, but I didn't assign prior to recalibrating.

[motogman]

You set your radio up same way as you would for a real heli but you select 1 servo for swash type. set your flight conditions your hold and whatever else you want. Now assign a switch for everything, I only use switch E for normal and ideal ups as well as for my D/R rates all same switch E. I then use switch G for throttle hold this is exactly how all my real helis are setup.

Now go in and calibrate everything as a new radio select the A9 then choose your heli next go to edit that model and select rotor governor put a check in enable advanced governor set the head speeds you want and and hit finished. now go to T.curve set normal to a 0 then flat line like this 0-27-27-27-27-27 -27 % Ideal 1 flat 50% and ideal 2 flat 100% this is if you want to use governor in the sim. now adjust your D/R in the radio I usually set normal to 65% for aileron and elevator 85% for both at ideal 1 and 100% ideal 2 set as you like and to match your real model.

Hope that helps

[Moktor]

Hmm, even after re-calibrating and setting up a new control it doesn't recognize the switches. I must be missing something here.

[Moktor]

Nevermind, after some time in the manual I got it =) Thanks.