START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Synergy Model Helicopters Synergy Model Helicopters Support |
|
LinkBack | Thread Tools | Display Modes |
12-14-2013, 08:53 AM | #1 (permalink) |
Registered Users
Join Date: Dec 2012
|
E5 vbar and ar8000 wireing ideas
Hey guys I was having a ton of errors with the vbar and sats, so I got a ar8000 and I know it will just work now lol. But I'm struggling to figure out how to mount everything cleanly. I looked through the picture thread but not many people running this setup.
|
Sponsored Links | |||
Advertisement |
|
12-14-2013, 12:43 PM | #2 (permalink) |
Registered Users
Join Date: Mar 2008
|
I would stack the receiver and vbar unit on the boom mount and put the sensor on the gyro plate on the bottom.if you are flying 6s you could put the receiver and main unit on the back battery tray and sensor on boom mount or gyro plate
__________________
Trex 500 12s vbar I2 bling Furion 600 12s vbar I2 bling trex 700edl vbar 12s I2 bling Tdrex 800e 12s vbar I2 bling Bank account EMPTY |
12-23-2013, 08:35 PM | #3 (permalink) |
Registered Users
|
+1 I'm thinking sensor on the plate on top the boom mount, or underneath while putting the vbar unit in the other spot or on the canted plate that forms the back of the battery tunnel.
Eg, when I had a beastX for a few trial runs early on, the microbeast was on the boom block panel, with an 7ch spekky underneath with a sat on the side (if using spekky sats, keep in mine the left element (label side up) is the active element and should be kept clear of CF). Now it's an iKon/Brain up top with a sat on both sides. Wiring an E5 is fairly easy....once you figure out where you want everything
__________________
"You need more rockets. Everything is better with rockets" Mike Dipalo--Synergy RC, MKS Electronics |
Thread Tools | |
Display Modes | |
|
|