Register Now

rstekeur · 06-12-2012, 06:06 PM

Any one know of a link on setting up end points. Im try on going over the setup on a newly built raptor. I didnt find anything on raptor technque

tr911 · 06-13-2012, 08:58 AM

All end points should be set at 100% except the throttle and it should be adjusted according to raptortechniques to get the full range of the throttle and keep from binding. You can down load the manual and it will help you.

06-12-2012, 06:06 PM	#1 (permalink)
rstekeur Registered Users Join Date: Dec 2011	End point setup Any one know of a link on setting up end points. Im try on going over the setup on a newly built raptor. I didnt find anything on raptor technque __________________ Blade 450x Trex 500 ELF Scale AS350 Trex500

06-13-2012, 08:58 AM	#2 (permalink)
tr911 Registered Users Join Date: Sep 2010	All end points should be set at 100% except the throttle and it should be adjusted according to raptortechniques to get the full range of the throttle and keep from binding. You can down load the manual and it will help you. __________________ Titan x50 FBL, R50 Titan SE FBL, R50 V2, R30 V2 , Trex500, T-Rex 450x2, mCPx X2,

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Register Now

Log-in