Mqx flips

[twoslick2]

My mqx has been sitting for awhile maybe 2 months. I decided to take it out and fly it the other day because there was no wind. When i tried to liftoff both rear rotors stopped turning and it flipped over. I don't think both motors would go bad at the same time. Anybody else had this problem and what did you do to fix it? Thanks

[ronj]

Originally Posted by twoslick2

My mqx has been sitting for awhile maybe 2 months. I decided to take it out and fly it the other day because there was no wind. When i tried to liftoff both rear rotors stopped turning and it flipped over. I don't think both motors would go bad at the same time. Anybody else had this problem and what did you do to fix it? Thanks

Any chance one or two of the blades are incorrect/reversed?

[twoslick2]

ronj the mqx flew when I last had it out but then after it sat it's the rear rotors tat just stop turning. The blades are correct. Sometimes they will turn but on liftoff they stop.

[ronj]

If the blades are right and there is no dirt in the gear/pinion to stop it then I would try to rebind it and make sure your trims are all centered. Then leave MQX steady on it's back or skids for it to initialize.

Hope you get it going, it's too much fun to sit on a bench.

[twoslick2]

I'll give it a try.

[twoslick2]

Thanks ronj ! I rebound and it's working ! I'll be flying in the morning Thanks again !

[ronj]

Hooray

Happy flying