Radio ATV and quark

[devens]

I am trying to program my quark gyro and I am stuck at the servo travel. The manual says to be in set-up mode 2 or 3 for low and high endpoint adjustments respectivly. The manual then states to move the rudder stick to prevent binding and press set-up button to store. When I get to step 2 in set-up nothing happens when I move my rudder stick. As a matter of fact my tail doesn't move in any of the 3 set-up steps.

I don't think the servo/gyro is bad I just think I don't understand the manual and someone is going to have to point me in the righ direction.

ty

D

[kazager]

I can't explain it any better than the manual. I haven't heard anyone complain of the way the instructions are written. I've got 3 Quarks, and I have had to refer to the manual every time. Is there a Finless video on the Quark that might help you.

[kazager]

https://www.helifreak.com/showthread.php?t=176987

[devens]

Originally Posted by kazager

https://www.helifreak.com/showthread.php?t=176987

I did a search posted. All I got was the ds760 review. I figured they were similar but wasn't going to assume they were. Sorry for asking

[devens]

Originally Posted by kazager

I can't explain it any better than the manual. I haven't heard anyone complain of the way the instructions are written. I've got 3 Quarks, and I have had to refer to the manual every time. Is there a Finless video on the Quark that might help you.

congrats

[kazager]

I'm trying to help, if you can't take a little ribbing, sorry.

[nexgen]

does the servo move when you move the rudder under normal operation (not in setup mode)?