ikon and dmss

[dredknot]

Hello everyone
I having a very hard time getting my ikon to work at all.
I have a JR xg14 with the 7channel x-bus rx and I'm trying to get it set up on the x-bus on the JR.
I may have the wiring wrong, looking at the diagram in the soft wear I'm not sure of how wire it.
making it more difficult if the fact that I'm new to JR transmitters.
I have tried different way of wiring but I can't get any movement on the computer or on the heli.
I tried a set up using a standard rx setup and everything moved, not in the correct direction but I got movement in both the computer software and on the heli ,so I'm guessing the fbl unit and the tx are working fine.



Need help please

[doujoh]

I think you have to set the TX to xbus-b if I remember corectly. Then wire the signal wire from the xbus port on the rx to the connection on the far left on the ikon and the - and + wire to the connection next to it on the ikon. But it's easier to see the wiring in the software. The ikon should be set to the hott reciever.
Hope this helps.

[dredknot]

thanks for trying to help doujoh.
Are you sure rx has to be set to Hott I was told to use ppm