Register Now

gunshine · 04-02-2011, 04:09 PM

Is there any reason I cannot use the stock mCX2 charger along side the stock Celectra charger?

It reads 1-Cell 3.7V 0.3A and has a red LED indicator for charge status. I have the AC power supply and an adapter cable. I figure until I get a real charger why not charge all 6 batteries during the time it takes to charge 5 (or maybe 4) using the stock charger alone.

RedOctobyr · 04-02-2011, 04:20 PM

Should be fine. It will just be slower. It will, naturally, match the speed of the mCP X's charger if you set that to 0.3A. With the charger adapter cable, you should be all set. I have used my 4-port mSR charger the same way. Slower than the mCP X's charger, but it does the same thing.

04-02-2011, 04:09 PM	#1 (permalink)
gunshine Registered Users My HF Map location Join Date: Dec 2010	Use mCX2 charger 1-cell 3.7V 0.3A? Is there any reason I cannot use the stock mCX2 charger along side the stock Celectra charger? It reads 1-Cell 3.7V 0.3A and has a red LED indicator for charge status. I have the AC power supply and an adapter cable. I figure until I get a real charger why not charge all 6 batteries during the time it takes to charge 5 (or maybe 4) using the stock charger alone. __________________ mSR X mCP X -CP maiden flight 3-26-11 DX7 - Phoenix 3

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

04-02-2011, 04:20 PM	#2 (permalink)
RedOctobyr Registered Users My HF Map location Join Date: Jan 2011	Should be fine. It will just be slower. It will, naturally, match the speed of the mCP X's charger if you set that to 0.3A. With the charger adapter cable, you should be all set. I have used my 4-port mSR charger the same way. Slower than the mCP X's charger, but it does the same thing.

Register Now

Log-in