Register Now

landmissle · 12-11-2008, 10:07 AM

I looked thru the manual for the default voltage of the BEC. I'm assuming it is set to 5V. Am I missing something???

haha101 · 12-11-2008, 10:31 AM

what tail servo will you be using if a 9257 u can run at 6v with a step down

Blueabyss · 12-11-2008, 10:34 AM

I think the Default is 5.5v . You can change it to 5.0 or 6 . Most people are running 6 with a step down for the tail servo.

Chris

CHCHGSR · 12-11-2008, 11:19 AM

Quote:

Originally Posted by Blueabyss

I think the Default is 5.5v

yep dead on the money 5.5v - Finless video 4:30secs in step15esc setup.
http://video.helifreak.com/?subpath=...=step15esc.wmv

HeatShrink · 12-11-2008, 03:03 PM

My RCE-BL60G was at 5V fresh out of the kit.

ace22459 · 12-11-2008, 06:11 PM

5.5 volts is the default setting according to the manual but that doesn't mean that it actually came that way. That's one of the reasons Finless suggests programming the ESC when you get it even if you want to use factory defaults. It gets you accustomed to programming it plus you make sure it's programmed right. Mistakes can be made at the factory.

12-11-2008, 10:07 AM	#1 (permalink)
landmissle Join Date: Dec 2008	Default voltage of trex 500 BEC I looked thru the manual for the default voltage of the BEC. I'm assuming it is set to 5V. Am I missing something???

12-11-2008, 10:34 AM	#3 (permalink)
Blueabyss Registered Users Join Date: Feb 2007	Default I think the Default is 5.5v . You can change it to 5.0 or 6 . Most people are running 6 with a step down for the tail servo. Chris

12-11-2008, 06:11 PM	#6 (permalink)
ace22459 Registered Users Join Date: Sep 2007	5.5 volts is the default setting according to the manual but that doesn't mean that it actually came that way. That's one of the reasons Finless suggests programming the ESC when you get it even if you want to use factory defaults. It gets you accustomed to programming it plus you make sure it's programmed right. Mistakes can be made at the factory. __________________ Blade CX/2, Axe CP, T-Rex 450 SA(SE V2 now) , T-Rex 600nitro Pro, Blade mCX, T-Rex 500 GF, T-Rex 450 SE night rig with ZeroGear and FlexPro lighting, Walkera 4G3, scale 450 Hughes 500D, Hirobo SDX HPM, Blade mSR, DX7

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

12-11-2008, 10:31 AM	#2 (permalink)
haha101 Registered Users My HF Map location Join Date: Feb 2008	what tail servo will you be using if a 9257 u can run at 6v with a step down

12-11-2008, 03:03 PM	#5 (permalink)
HeatShrink Join Date: Jul 2008	My RCE-BL60G was at 5V fresh out of the kit.

Register Now

Log-in