Register Now

puma1824 · 08-23-2009, 12:25 AM

Can someone using a Mikado FBL head conversion for the T700 measure the distance between center mainshaft and center of the blade grip control arm balls? Like the pic below. Furthermore, what distance from ball to ball on the servo arm/wheel are you running? What is your collective common and min / mix pitch at that setting?

Thanks in advance.

Skint Eastwood · 08-23-2009, 02:14 AM

head ..... ball to centre 38
ball to ball .....servo 22
pitch +- 13

Have tamed the pitch down somewhat +-18 would be the max at this geometry

I use the skookum 360 and its electric if that makes any difference

sorry just read 'collective common' so i guess you want people with Vbar

4cyclic · 08-23-2009, 07:42 AM

same here 10.8 mm on each side of horn, -13 to +13 pitch.

marke · 08-28-2013, 01:39 PM

hello i have a question on using this conversion-does the head shack when at 1600 to 1700 head speed? at 1800 rpm it smooths out but below that seemed very un stable--all is straight and tight but bad head shack.

thank you for any help

08-23-2009, 12:25 AM	#1 (permalink)
puma1824 Registered Users Join Date: Jan 2008	Flybarless T700 / Mikado Conversion Questions... Can someone using a Mikado FBL head conversion for the T700 measure the distance between center mainshaft and center of the blade grip control arm balls? Like the pic below. Furthermore, what distance from ball to ball on the servo arm/wheel are you running? What is your collective common and min / mix pitch at that setting? Thanks in advance. __________________ Team Synergy- YS Engines - Coolpower

08-23-2009, 02:14 AM	#2 (permalink)
Skint Eastwood Join Date: Apr 2008	head ..... ball to centre 38 ball to ball .....servo 22 pitch +- 13 Have tamed the pitch down somewhat +-18 would be the max at this geometry I use the skookum 360 and its electric if that makes any difference sorry just read 'collective common' so i guess you want people with Vbar Last edited by Skint Eastwood; 08-23-2009 at 03:33 AM..

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

08-23-2009, 07:42 AM	#3 (permalink)
4cyclic Registered Users Join Date: May 2004 Location: Northern Vermont	same here 10.8 mm on each side of horn, -13 to +13 pitch.

08-28-2013, 01:39 PM	#4 (permalink)
marke Registered Users Join Date: May 2006	hello i have a question on using this conversion-does the head shack when at 1600 to 1700 head speed? at 1800 rpm it smooths out but below that seemed very un stable--all is straight and tight but bad head shack. thank you for any help

Register Now

Log-in