Installing kst215 servos on cyclics

[Bhujang]

Hi

Has anyone installed the kst 215 servos on the 450x? How do you get the top, right cyclic servo in? To get the bottom one in I have to go in at a 45 degree angle then bring it flat. Once that ones in no way to do the same on the other side. Basically the cable has a rubber support around where it enters the case which makes it thicker and harder there. Can't get it in at all. Maybe the 450x is just a rubbish design maybe there is a super technique? I did think about taking it apart to get it in then re assembling it once in. hope I don't have to do that.

Any ideas appreciated.

Cheers

[Bhujang]

Well I persevered and used a bit more force than I would have liked but got them in changed tactic and put the top one in first then the lower one. Gently pulling the cable and pushing from the servomside it squeezed in somall is well now as long as the wires aren't damaged they look good though

[wsucnc]

I had HiTec's in my Microheli CF frame. Then there was a suggestion that I change to KST215's when I had problems with my iKon. I didn't notice any improvement in servo function but I did get a nice headache trying to figure out how to get them to fit.

[Bhujang]

I got them all installed now. Wow the difference to stock especially on the tail is amazing.