DX7 thr to thr mix for cut with GV1

[Jdeiter]

Prior to installing the GV1 on my Radikal G30, I was using the finless thr to thr mix on my gear channel as a throttle cut. I just installed a GV1 and now I noticed that my mix no longer works as a throttle cut. Any ideas???

[Soarmax]

Originally Posted by Jdeiter

Prior to installing the GV1 on my Radikal G30, I was using the finless thr to thr mix on my gear channel as a throttle cut. I just installed a GV1 and now I noticed that my mix no longer works as a throttle cut. Any ideas???

Can you move the Throttle Cut to a different switch?

[aerocal]

Im not real familiar with the GV-1 but I wouldnt think it would be acting on the throttle at the low end.Only thing I can think of.If your throttle endpoint was close to 100 for low before and the cut was driving it below 100 to shut it off the GV-1 may be stopping it at 100.You might try to bias the linkage so that the motor stops no farther than -100 and reset everything.If you know what I mean.

P.S. Reread your OP and yes if your now using gear channel for gyro gain you might need to use a different switch.Oh dang...It only allows gear,FM or hold.Ok I have to rethink this.