06-27-2016, 06:33 AM
|
#2 (permalink)
|
Registered Users
|
Quote:
Originally Posted by N0xx187
So I picked up a used p2 and the reciver is dead so I did was digging and pulled out a AR600 and a dx6i in had laying around..I've searched and searched..watched tons of your tube videos and can't get this to work..any help would be sweet...from wireing to AR600 to the p2 naza and programing the DX6i would be vary much appreciated thanks
|
From my memory, youll have to run a wire from each of the six channels into the Naza, and then youll have to go into the program, click the little phantom tab in the top right corner to get into advanced mode, then go to the controller tab and change the input method. Its currently set for S-Bus from the manufacturer and Spektrum controllers dont do S-Bus.
|
|
|