Share your config file

[StoneGod]

Originally Posted by nexgen

Hi all,

Please share your config file, as well as describe the setup. It may work well for others with similar setups, or at least give them a place to start. It can't hurt to just attach the file here.

Heck I'm running Bert K's config file on my Gaui 200 and my setup is completely different. I have a different tail servo, different tail blades, belt tail (he had tt), and am flybarless. Without changing a thing it is working great.

You wouldn't happen to have Bert's config for his Trex 450 would you???

Here is my setup:

Trex 450se V2
JR 3500G tail servo
5:1 tail to main gear ratio
350mm blades
Belt drive
K&B tail blades

...and here is my current config. file (please note I currently have a slow counter-clockwise drift that I have yet to find a fix for using this config.).

If anyone can point out a fix for the tail drift issue, that would be great.

[nexgen]

ask and ye shall receive. this was on Bert's site:

http://www.bertrc.com/archives/66

[StoneGod]

Originally Posted by nexgen

ask and ye shall receive. this was on Bert's site:

http://www.bertrc.com/archives/66

Thank-you soooo much!!

I'll upload it into my DS760 and see how she does!!

[jndell]

Sweet sticky!! Where's all the ds760 owners out there?
here's my $.02

Align T-Rex 500 ESP
Align DS510 cyclic
JR ds3500G Tail
Spartan ds760
AR7000+Dx7se
Stock main/tail blades
Stock moter/ESC/13T
3cell Zippy lightmax 2200 25C X2

[dpeagle]

settings for 4s rave. radio jr9303 - rudder travel 120 both directions

[Bob O]

I just took this off the Sticky list for obvious reasons. Lack of participation, last post over three years ago, etc.

I can see it possibly getting replaced by a Vortex config thread, possibly.