GY611 Limit change.

supertrex2 · 07-17-2006, 09:11 AM

According to Finless Video. The recommended limit is around 100 to 115.

I tried 102 and everytime I turn my rudder stick to left and right... servo makes this weird Noise... and the wire is bending. ( servo is already centered )

So I assume my Limit is too high. then.... I went down to 80% limit.

When I go left stick... the Servo makes noise. So I assume its touching again.

Went down to 70% limit and everything went smooth. No binding. and it can go left and right with ease....

Just asking coz they said if we go less than 80% thats not good. any comment?

pilotError · 07-17-2006, 09:25 AM

You should be over 100% on the limits.

Get a smaller servo horn and move the linkage to the inner most hole.

Mike...

07-17-2006, 09:11 AM	#1
supertrex2 Registered Users Join Date: May 2006 Location: Florida	GY611 Limit change. According to Finless Video. The recommended limit is around 100 to 115. I tried 102 and everytime I turn my rudder stick to left and right... servo makes this weird Noise... and the wire is bending. ( servo is already centered ) So I assume my Limit is too high. then.... I went down to 80% limit. When I go left stick... the Servo makes noise. So I assume its touching again. Went down to 70% limit and everything went smooth. No binding. and it can go left and right with ease.... Just asking coz they said if we go less than 80% thats not good. any comment? __________________ oh ohh its going down...S$%#T...relax.. relax.... concentrate......try to control.. oooops too late... already crashed!

07-17-2006, 09:25 AM	#2
pilotError Registered Users Join Date: Apr 2004 Location: Long Island, NY	You should be over 100% on the limits. Get a smaller servo horn and move the linkage to the inner most hole. Mike... __________________ Good Judgement comes from experience, Great Judgement comes from bad experience.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode