cp3 help? newbee

crash47 · 11-23-2009, 07:42 PM

any know if setup on a cp3 is blades and flybar level with everything center on tx ,far from how it came with a servo arm far from 90 degrees ,rtf? any help appreciated

Dusty1000 · 12-02-2009, 05:39 AM

Yes, disconnect the motor, power up and put it into idle up mode, then

Quote:

Originally Posted by crash47

blades and flybar level with everything center on tx

that sounds fine - push the collective stick from one end to the other, and check that nothing binds

Dusty

11-23-2009, 07:42 PM	#1
crash47 Registered Users Join Date: Nov 2009 Location: elkins wv	cp3 help? newbee any know if setup on a cp3 is blades and flybar level with everything center on tx ,far from how it came with a servo arm far from 90 degrees ,rtf? any help appreciated

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode