Old DX7 > New DX7

InaFix · 02-17-2010, 01:13 PM

Just bought a NEW DX7... going to sell old DX7 to new flyer in the neighborhood. Once I rebind the TX/RX's will the same adjustments carry over between the two Transmitters without any problems and no need for additional setup?

Sorry, I just re-read the post. I intend to manually copy the different values to the new Tx...

[ed]

RocketSled · 02-17-2010, 01:41 PM

With the exception perhaps of some trim values, the new radio will behave exactly the same as the old. The only differences will be in the minor variances of the analog stick potentiometers. Everything else is just an on/off switch (including trim tabs) = no calibration differences at all.

InaFix · 02-17-2010, 02:53 PM

Rocket, thanks for the quick reply.

Soooo, if I just input the same sub-trims, EPA's, etc, from the old radio to the new radio and bind same as per respective Rx, I should be OK?

[ed]

RocketSled · 02-18-2010, 10:21 AM

Quote:

Originally Posted by InaFix

Rocket, thanks for the quick reply.

Soooo, if I just input the same sub-trims, EPA's, etc, from the old radio to the new radio and bind same as per respective Rx, I should be OK?

[ed]

With the possible exception of a few clicks of trim here or there...

02-17-2010, 01:13 PM	#1
InaFix Registered Users Join Date: Jan 2008	Old DX7 > New DX7 Just bought a NEW DX7... going to sell old DX7 to new flyer in the neighborhood. Once I rebind the TX/RX's will the same adjustments carry over between the two Transmitters without any problems and no need for additional setup? Sorry, I just re-read the post. I intend to manually copy the different values to the new Tx... [ed]

02-17-2010, 01:41 PM	#2
RocketSled Registered Users Join Date: Sep 2008	With the exception perhaps of some trim values, the new radio will behave exactly the same as the old. The only differences will be in the minor variances of the analog stick potentiometers. Everything else is just an on/off switch (including trim tabs) = no calibration differences at all. __________________ Fly in the street hangar includes: T-Rex 450SEV2, 250SE (MD500), Blade 400, SR & mSR & 120SR & mCPx & mCX & CX2, Walkera 4G6S & SeaCobra Parkzone Sukhoi (& XP), Centurion, Mustang (Micro and BL versions), µBeast, Mosquito

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

02-17-2010, 02:53 PM	#3
InaFix Registered Users Thread Starter Join Date: Jan 2008	Rocket, thanks for the quick reply. Soooo, if I just input the same sub-trims, EPA's, etc, from the old radio to the new radio and bind same as per respective Rx, I should be OK? [ed]