Suzi Hans 700E - Page 2

Danal Estes · 04-12-2010, 01:04 PM

Any open servo or RX jumper port, or a Y connector if none open.

Do NOT use the Control Panel port to supply power. Nor any of the other ports on the "back" of the V-Bar. They are connected to common power, but they connect to the servo bus via relatively thin traces on the internal board.

SkinWalk3r · 05-07-2011, 04:35 PM

anyone know what pwm to set this motor at on the CC controllers ?

Danal Estes · 05-10-2011, 04:30 PM

Quote:

Originally Posted by SkinWalk3r

anyone know what pwm to set this motor at on the CC controllers ?

Meaning the X-Era? I don't know, but I'd call David at X-Era, or use the form on the X-Era website. I've found him to be VERY responsive.

04-12-2010, 01:04 PM	#21
Danal Estes Registered Users My HF Map location Join Date: Jul 2006 Location: Frisco, TX	Any open servo or RX jumper port, or a Y connector if none open. Do NOT use the Control Panel port to supply power. Nor any of the other ports on the "back" of the V-Bar. They are connected to common power, but they connect to the servo bus via relatively thin traces on the internal board. __________________ Trex 700E - SuziHans,V-Bar,JR8717/BLS251,X-Era 4030/3Y-460,12S Rhino 4900; SH frames are ~1 Lb lighter than Align 700E kit Trex 700N - 7100R/JR8717@8V/GY611 About a dozen more, including 2xTrex 500 - 1 V-Stabi/6S, 1 Flybar/5S,GY770/DS3400G

05-07-2011, 04:35 PM	#22
SkinWalk3r Registered Users Join Date: Nov 2008 Location: pontiac, mi	anyone know what pwm to set this motor at on the CC controllers ? __________________ AMA # 865413 Mikado Logo 600SE. Align T-Rex 600 ESP Airwolf. DJI flamewheel 550.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode