DIY night tail blades 95mm

pwkpete · 08-31-2011, 11:22 AM

Wondering if anyone else has made their own night tail blades...

I have started to build a set, pretty much wired up, but still am a little concerned over the high tail RPM and extra weight (1.5g) offset from the center of the blade. This is on a Logo 600 tail with 2 radial bearings and 1 thrust... I don't think the weight itself is an issue, more the offset.

I do use high strength 3M tape to hold the cell down, then use shrink to press it to the blade so it won't shoot out as I do with my mains.

Anyone with experiences?

08-31-2011, 11:22 AM	#1
pwkpete Registered Users Join Date: Nov 2004 Location: Pewaukee, WI USA	DIY night tail blades 95mm Wondering if anyone else has made their own night tail blades... I have started to build a set, pretty much wired up, but still am a little concerned over the high tail RPM and extra weight (1.5g) offset from the center of the blade. This is on a Logo 600 tail with 2 radial bearings and 1 thrust... I don't think the weight itself is an issue, more the offset. I do use high strength 3M tape to hold the cell down, then use shrink to press it to the blade so it won't shoot out as I do with my mains. Anyone with experiences? __________________ LAHeli Ricco / Sniper, MSH mini Protos / Protos - YGE/BeastX - ElektroRC

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode