Fun, Learning, Friendship and Mutual Respect
START  HERE


Unregistered
Go Back   HeliFreak > R/C Helicopter Support > Blade Helicopters (eFlite)


Blade Helicopters (eFlite) Blade Helicopters (eFlite) CP, CX, mCX CX II, CX III. and others


Reply
 
Thread Tools Display Modes
Old 01-10-2012, 10:46 AM   #1
Ponchota
Registered Users
 
Posts: 1,027
 

Join Date: Oct 2011
Location: US, NH,
Default Blade CP 2n1 mixer help

I have been slowly putting together a modded CP. It has a cool flight tech all alum. frame tail skids etc. I also have a complete CNC head on it. I picked up the SR DD tail for it and have the 2n1 with mixing pot and Spektrum 6100e RX with Detrum GY48V HH Gyro. My problem at the moment is wiring this thing up. How do I connect the tail motor wire, gyro and 2n1 all together with the RX. The SR manual is of no help to me is useless for my needs. Normally tail wire goes into 2n1 but then how would gyro work? If it goes into gyro then how, and what about mixing pot for 2n1. Thanks
Ponchota is offline        Reply With Quote
Reply




Unregistered
Go Back   HeliFreak > R/C Helicopter Support > Blade Helicopters (eFlite)


Blade Helicopters (eFlite) Blade Helicopters (eFlite) CP, CX, mCX CX II, CX III. and others

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


Copyright © 2004-2015 by RCGroups.com, LLC except where otherwise indicated. The HeliFreak.com logo is a trademark of RCGroups.com, LLC.