X50E with beast X

devilfish · 06-17-2012, 04:50 PM

Hello

As the X50E use push-pull linkage. I wounder if you need to move in the balls on the servo horns to get enough resolution for the Beast X cyclic setup?

Cheers

Bob O · 06-17-2012, 05:03 PM

10 to 12mm ball spacing should get you near to blue at 6 degrees.

Sent from my phone

devilfish · 06-18-2012, 06:40 AM

Thanks

06-17-2012, 04:50 PM	#1
devilfish Registered Users Join Date: Jun 2009 Location: sweden	X50E with beast X Hello As the X50E use push-pull linkage. I wounder if you need to move in the balls on the servo horns to get enough resolution for the Beast X cyclic setup? Cheers __________________ /// JR DSX9 2.4 \\\ /// TREX 450 SE v2 \\\ ///TREX 250 \\\ /// HYPERION 720i Net 3 \\\ /// PHOENIX Sim \\\

06-17-2012, 05:03 PM	#2
Bob O HF Support My HF Map location Join Date: Dec 2008 Location: Negaunee, Michigan	10 to 12mm ball spacing should get you near to blue at 6 degrees. Sent from my phone __________________ Warp 360 Spartan Vortex VX1

06-18-2012, 06:40 AM	#3
devilfish Registered Users Thread Starter Join Date: Jun 2009 Location: sweden	Thanks __________________ /// JR DSX9 2.4 \\\ /// TREX 450 SE v2 \\\ ///TREX 250 \\\ /// HYPERION 720i Net 3 \\\ /// PHOENIX Sim \\\

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode