Help needed on 4G6S w/ 2622V

maverickk · 07-28-2012, 11:52 PM

I upgraded my 4G6S Rx with the 2622V and I cannot get it to send the correct control to my servos. Left stick acts make the front servo (elevator) go down and the back two servos A/P to go up when the stick is pushed forward (rudder control is correct). The right stick roll is correct, but pushing the stick causes all three servos to move up, but the elevator servos moves much faster than the two rear servos. I verified my mode is set to 2 and if have tried reversers, changing my swash, but not matter what I do, I get similar results. I tripled checked my servo connections. Any suggestions?

Thanks

maverickk · 07-29-2012, 04:38 AM

I posted on RC Groups and got the answer - swap the PIT and AIL servos - that did the trick.

07-28-2012, 11:52 PM	#1
maverickk Registered Users Join Date: Feb 2010 Location: Hawaii	Help needed on 4G6S w/ 2622V I upgraded my 4G6S Rx with the 2622V and I cannot get it to send the correct control to my servos. Left stick acts make the front servo (elevator) go down and the back two servos A/P to go up when the stick is pushed forward (rudder control is correct). The right stick roll is correct, but pushing the stick causes all three servos to move up, but the elevator servos moves much faster than the two rear servos. I verified my mode is set to 2 and if have tried reversers, changing my swash, but not matter what I do, I get similar results. I tripled checked my servo connections. Any suggestions? Thanks __________________ RC Heli Pilot = Control Freak

07-29-2012, 04:38 AM	#2
maverickk Registered Users Thread Starter Join Date: Feb 2010 Location: Hawaii	I posted on RC Groups and got the answer - swap the PIT and AIL servos - that did the trick. __________________ RC Heli Pilot = Control Freak

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode