Fun, Learning, Friendship and Mutual Respect
START  HERE


Unregistered
Go Back   HeliFreak > R/C Helicopter Support > Blade Helicopters (eFlite) > Blade 500X


Blade 500X Blade 500X Helicopters Information and Help


Reply
 
Thread Tools Display Modes
Old 05-30-2013, 12:07 AM   #1
Chevy guy
Registered Users
 

Join Date: May 2013
Location: Canada,Manitoba,Winnipeg
Default Blade 500 3D Problems

Have a new Blade 500 3D.Purchase a bunch of upgrades.Put on aluminum blade grips and bell mixer set.The ball link on short rod side of bell mixer is binding on grips.If I move to outer hole on bell mixer what does this do.Thinking of putting in a washer to bring bell mixer out so doesn't interfere with grip.Any ideas or has any one else had this problem ? Thanks
Chevy guy is offline        Reply With Quote
Old 05-30-2013, 01:27 PM   #2
cory r
Registered Users
 

Join Date: May 2009
Location: Columbia, SC US
Default

pics/vid? For those who don't have that heli...

Adding washers may mess with the mixing/geometry a bit. If it is the hole adjustment that I am thinking, your roll and flip rates will decrease.

Again, I think some pics or video of the interference would help.
__________________
Bad Terraferma!.....BAD!!
cory r is offline        Reply With Quote
Reply




Unregistered
Go Back   HeliFreak > R/C Helicopter Support > Blade Helicopters (eFlite) > Blade 500X


Blade 500X Blade 500X Helicopters Information and Help

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


Copyright © 2004-2011 - William James - Helifreak.com