Mezon 90 controller setup question

[btracey1]

Hi Guys,I'm new to the Jeti system and must admit to being overwhelmed.
Through the DS16 JetiBox I am Trying to go through the Controller Set-Up Menu.
At this point I'm trying to get a Mezon 90 installed and set up on a Goblin 500 with a Quantum 4115-1200 motor, Jeti R7 plus US Rx.
It seems that some input I'm putting in is wrong. As I went step by step through the Controller Set-Up Menu I entered; Operation Mode <constant RPM>, Motor Poles <8>, Rotor Gear < 1: 9,7> (as per Goblin Manual... 17T Pinion= ratio. 9.72:1) then this is where something is wrong because the next step is to set MaxRotor RPM, but the lowest it will allow me to set is 10000 RPM.... I'm trying to get around 2400 RPM.
Any suggestions or ideas, would be greatly appreciated!

Sorry guys....figured it out...the lower limit was set at 100000 by default, once that was lowered I could set the desired RPM


Brian

[desertstalker]

Originally Posted by btracey1

Sorry guys....figured it out...the lower limit was set at 100000 by default, once that was lowered I could set the desired RPM


Brian

Heh, had exactly the same issue, they need to swap the min and max order methinks.

[Puttputt maru]

Yes it is a slight "flaw" in the logical steps when you set up the Mezons. The minimum should be before the maximum. At first I didn't even noticed the extra "0" so my headspeed was quite high

I wonder why they also set the default number so high innthe first place ?

[im4711]

I had a similar issue on my first Mezon. Could be the initial value is because you could use it for planks and they may need it in that area.