View Single Post
Old 06-18-2006, 09:56 AM   #80 (permalink)
Finless
Team Taco VP
 
Posts: 34,528
Thread Starter Thread Starter
 
My HF Map location
Join Date: Nov 2005
Default

No it is not just you... This is the problem with the CCPM version of the XL.
The easiest fix is to drill the holes for the canopy pins farther forward on the frame which will move the canopy up and forward a bit and they will clear. Another way but can cause a tiny bit of geometery problems is to flip the servos so the output shafts are at the bottom. I did one this way and it worked out fine.
One other way is to dump the push pull setup fromt he servos and only use the bottoms of the two bell cranks.
Even others have cut holes inthe canopy (yuck).

Bob
Finless is offline        Reply With Quote