View Single Post
Old 12-21-2010, 04:44 AM   #24 (permalink)
Registered Users

Join Date: May 2006

The "Hacker ESC" interface and the "Multiplex USB to RX" interface should be compatible with the microbeast.
!!! Attention !!!
You have to make sure then that the middle connector (power / red) is not connected (pull it out of the connector), otherwise you might burn down your PC's USB hub by powering the complete Heli electronics including servos from it.


The circuit with the diode was wrong, as the diode was inserted in the wrong direction.You also missed the pull up on the single line and you have to use a schotky diode that has not more than 0.2v to 0.3v @ a couple of mA. (e.g. BAT64-02W...)
labmaster is offline        Reply With Quote