Great build thread and videos!
Question on the servos-- on Finless Bob's build videos he uses the outermost links on all 3 cyclic servos to work around the servo shoulder, which results in a little bit of neg. angle when at 90, but his comment was that since all 3 were set up that way, it will work fine.
Wanted to check how that compares to this servo install where the elevator servo uses a washer and new ball to achieve the clearance.
Any strong preference on either method? I'm inclined to try Finless's setup first as I don't have these washers or new balls...
Thanks,
Chief
|