View Single Post
Old 06-21-2011, 03:52 AM   #39 (permalink)
Registered Users
Posts: 538

Join Date: Jan 2011

Originally Posted by Ampdraw View Post
The three pin futaba style connector is going to be power + - and signal out while the wire by itself will be signal in.
However it may not work properly as it was programmed for walkera rx signal which is vastly different to the Mcpx.
Me, I wouldn't take the gamble. It'll be heavier too.
My converter was shipped the same day and got to Aus in ten...can't complain there.

The wk003 motor has a 1.5mm shaft so the stock 1mm bore pinion won't work and there's not enough meat to drill it out unless you are a pro on a mini lathe. I buggered up one trying to hand drill it super carefully!

Thanks amp!

Yea I'm still trying to get the pinion somewhere or a least the part number for the gas pinion (I work at a Hobbytown so if onl I had the part number..)
I'm just gonna try to drill the stock one with a 1.5 bit if i can't find the 9t anywhere

And yeah I didn't risk getting the futaba plug converter from wowhobbies (wish they had the steve one in stock) so I just ordered one from and hopefully it'll get here before 10 days since im in California.
Souskei is offline        Reply With Quote