View Single Post
Old 06-22-2011, 10:12 PM   #52 (permalink)
dbennettya
Registered Users
 

Join Date: Apr 2010
Default

If someone had a donor motor we might be able to see if it is possible to remove the main shaft and turn it down to 1mm on a lathe. It appears that is what was done on the shaft of the one I got from CJ. According to CJ there are a lot of dead C05 motors out there due to the screws being too long and damaging the windings. My motor came with screws that were a little long but ok. I used the stock mCP X screws and they are just right.

Another possibility is to see what the minimum buy size would be for some C05 motors with the 1mm shaft mod. Or maybe we can get them to make it a standard. AeoRC are you listening?

YMMV, Don
dbennettya is offline        Reply With Quote