View Single Post
Old 06-24-2011, 09:17 AM   #54 (permalink)
adroc3905
Registered Users
 
Posts: 777
 
My HF Map location
Join Date: Dec 2008
Default

Ok what’s the trick here? Everything is wired correctly and all I get is a quarter spin on the main blades when I throttle up and then nothing else. I wired the yellow steve converter wire to the board (at the right spot) and the white/red/blk wires on the esc to the white/red/blue wires on the converter.

Not sure what is wrong. Does the esc or tx need to be programmed or set to recognize high and low throttle......like the castle esc's.

Edit: esc beeps when lipo is plugged-in however every so often the esc will go full throttle and respond to no stick input (high or low) from my tx and then other times the esc does nothing and I get no spin. I wonder if the converter is getting the signal from my tx to the esc.
__________________
TBS Discovery
Rave 450 FBL - miniVbar
Trex 500 ESP FBL - Beastx
Trex 600 ESP FBL - Beastx

Last edited by adroc3905; 06-24-2011 at 12:38 PM..
adroc3905 is offline        Reply With Quote