View Single Post
Old 07-18-2007, 01:14 AM   #3 (permalink)
Ticidytoc
Registered Users
Thread Starter Thread Starter
 
My HF Map location
Join Date: Aug 2006
Default

Next you will need to solder a short jumper to the board. I'm using a servo connection for this, you could use a micro deans as well. There is plenty of room inside the battery compartment to fit the connector if using the Flightpower EVO 1500 RX packs.

You could also use the stock wires to the JR plug on the board, or a set of micro deans for this. I used an extra servo connector for this, the wires lay flat on the back of the pack and the battery cover closes without any force.

I have seen some packs that fit so tightly the back cover bulges or puts pressure on the cells.
Attached Images
File Type: jpg dx7_3.jpg (276.5 KB, 2339 views)
__________________
A Helicopter, Brushless Motor, Esc, Battery, Servos, RX
Ticidytoc is offline        Reply With Quote