View Single Post
Old 07-18-2007, 02:33 AM   #5 (permalink)
Registered Users
Thread Starter Thread Starter
My HF Map location
Join Date: Aug 2006

Now drop your 1500 EVO pack in and store the wires.

Theres not much to it. You do not need to add the extra set of wires to the board, you can simply make up a connection to the stock JR plug from the original pack. I didnt want to cut my plug off the stock battery and I didnt care for the small ga. wires on the MPI JR plug so I used a servo connector from a 6' servo extension.

You could squeeze the 3s pack in without cutting the battery compartment, its tight and I didn't want to stress the wires on the pack. I also used the RX pack because of the smaller wires. Flightpower packs have 2 sets of leads on their RX packs, I removed one set and put shrink over the wires to protect against shorting.
Attached Images
File Type: jpg dx7_6.jpg (306.4 KB, 2213 views)
File Type: jpg dx7_5.jpg (208.7 KB, 1986 views)
A Helicopter, Brushless Motor, Esc, Battery, Servos, RX
Ticidytoc is offline        Reply With Quote